Selecting Trimming Tools
Before trimming rubber seals, appropriate trimming tools must be selected. Generally, trimming tools can be scrapers, cutting blades, etc. It is important to ensure that the chosen tools will not damage or harm the rubber seals.
Trimming Steps
The trimming steps mainly include the following:
1. Cleaning the Seal: Before trimming, the surface of the seal needs to be thoroughly cleaned to facilitate the trimming operation. Cleaning agents or scouring powder can be used.
2. Opening the Trimming Tool: Open the selected trimming tool, ensuring the blade is sharp for easy trimming, while also paying attention to safety.
3. Begin Trimming: Pick up the trimming tool, place the seal on the trimming table, and then carefully begin trimming. Appropriate pressure and angle should be used during trimming to ensure both effectiveness and safety.
4. Grinding: After trimming, the edges of the seal need to be ground to remove excess material and uneven areas. When sanding, you need to use tools such as fine sandpaper to ensure that the edges are smooth and clear.
